Front and Rear Seats
Correct Driving Position
The seat, head support, seat belt and airbags work together to maximize your safety. Using these correctly ensures greater protection.
Position the seat so you can wear the seat belt correctly, while being as far away from the front airbag as possible:
- Sit upright with both feet on the floor and the seat back in an upright position.
- Make sure you can easily reach the pedals and that your arms are slightly bent when holding the steering wheel. Your chest should be at least 10 inches (25 cm) from the center of the airbag cover.
- Place the shoulder section of the seat belt mid-way between your neck and your shoulder. Fit the lap section of the belt tightly across your hips, not across your stomach.
Adjusting Front Seats
- Move seat forward/backward and adjust the seat’s height and tilt angle up/down.
- Adjust backrest.
- Adjust lumbar support.
To adjust the front passenger seat using the touchscreen, touch
and use the arrows next to the front passenger seat visualization to move the seat forward or backward.Head Supports
The front seats and the rear outboard seats are equipped with integrated head supports that you cannot adjust.
The rear center seat is equipped with an adjustable head support that you can raise and lower:
- When the seat is occupied by a passenger that is not in a child safety seat, align the center of the corresponding head support with the center of the occupant's head, and ensure the head support is locked into position.
- When the seat is occupied by a child safety seat equipped with an upper tether strap, leave the head support in the raised position after routing the upper tether straps under it.
To raise the head support, pull it upward to the desired position. To lower it, press and hold the button on the base of the post on the right side of the head support while pushing the head support downward.
Removing/Installing the Rear Center Head Support
To remove the rear center head support:
- Fully raise the head support by pulling it upward.
- Press and hold the button located on the base at the right side of the head support.
- Insert a short, flat object (such as a small flat-head screwdriver) into the opening in the base of the opposite post and pull the head support upward.
To re-install the rear center head support:
- With the front of the head support facing forward, align both posts into the corresponding holes on the seat back.
- While holding the button on the base of the post, press downward on the head support until it clicks into place.
- Pull upward on the head support to ensure that it is secure.
Seat Heaters
All seats (except the rear center seat) are equipped with seat heaters that operate at three levels from 3 (highest) to 1 (lowest). For details on how to operate the seat heaters, see Climate Controls.